Yanmar SV18 Tilt Grading Bucket - 36" / 900mm Model T570

Yanmar SV18 Tilt Grading Bucket - 36" / 900mm Model T570Yanmar SV18 Tilt Grading Bucket 36" 900mm This heavy duty 36 inch tilting grading bucket is purpose built to fit Yanmar SV18 excavators. It connects to the same hydraulic circuit used for a thumb, allowing tilt control up to 45 degrees left and right (a total of 90 degrees). The bucket width is 36 inches (900 mm). Note: hydraulic hoses required to connect this attachment to your excavator are not included and must be sourced separately. When mounted,

60" Heavy-Duty Design: Optimized width for efficient breakout

Wear Protection: Extra armor on the back and underside shields vulnerable areas from abrasion and premature wear

Depth: 40 inches (1000 mm) digging depth for deeper utility runs while keeping the trench narrow

Compatibility & Width: 72" rake designed to fit Hyundai HX140A L excavators for efficient on-site clearing without complicated setup

You can visit the Support page on our website to locate a service center near you

0 Maximum Cutting Depth (Inches) 2

18" diameter with 9" flighting

enhancing efficiency and output

variable flow to place material exactly where it’s needed

level bottoms with fewer passes

The Linkbelt 130 X4 Excavator Rake Riddle Bucket - 72" offers a versatile solution for land clearing and sorting tasks

and the included pins streamline installation