PIR Motion Sensor (JST) shopbot

PIR Motion Sensor (JST) shopbotDescription: This is a simple to use motion sensor. Power it up and wait 1 2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the alarm pin will go low. This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3. 3V. Sensor uses 1. 6mA@3. 3V. The alarm pin is an open collector meaning you will need a pull up

and there are built-in flyback diodes as well

Check out our tutorial with Arduino and you can get our documented Arduino library which has both PWM and Servo examples from github

Alginate kit used for lifecasting

and then toggle it 3 times

3V voltage regulation

5GHz with built-in metal heatsink

6 address select pins so you can wire up to 62 of these on a single i2c bus

or Beagle Bone Black

Hall sensor

internal kickback protection diodes

720p60 and 640x480p60/90 video

It is 5V compliant